Mold Building
SECRETS OF PATTERN PREP & MOLD BUILDING
Learn the secrets of pattern preparation and mold making from Dr. Ray...see our tutorial videos below
Click Picture for more Info
Tooling resin is used for mould making. It has a higher resistance to deformation caused by exotherm temperatures.
Catalyst included with 3.78L orders
Click Picture for more Info
The purpose of pattern sealer is to seal the porous surface of the pattern.
Click Picture for more Info
The purpose of pattern sealer is to seal the porous surface of the pattern.
Click Picture for more Info
Compounded with the purest grade carnauba wax, plus special binders and spreading agents, Honey Waxx has been the leading choice in mold release agents for decades
Click Picture for more Info
A high-temperature version of Honey Wax formulated to work with higher exotherm resins up to 240°F. Honey Plus Wax is an excellent release agent where reproducibility, hi-gloss, non-staining, and a hard releasing film is important. It is easier to apply than our other wax release agents and the residual film is durable and resistant to abrasion.
Click Picture for more Info
Our easiest to use premium carnauba based mould release, agent. Works well in both cold and warm temperatures. Honey Wax® 250 reduces cycle times due to its exceptional ease of application and buffing. It is an excellent mould release agent providing reproducibility, high gloss, and a non-staining, hard releasing film which are important to the fabricator.
Click Picture for more Info
Compounded with the purest grade carnauba wax, plus special binders and spreading agents, Honey Waxx has been the leading choice in mold release agents for decades.
Click Picture for more Info
PVA should be used to aid in the release of parts from a mold. It should be applied in three thin mist coats.
Click Picture for more Info
PVA should be used to aid in the release of parts from a mold. It should be applied in three thin mist coats over.
Click Picture for more Info
PVA should be used to aid in the release of parts from a mold. It should be applied in three thin mist coats over...
Click Picture for more Info
PVA should be used to aid in the release of parts from a mold. It should be applied in three thin mist coats.
Click Picture for more Info
3.78L KIT includes part A & B
***OUT OF STOCK***
Click Picture for more Info
Kit includes 20 Kg of Part A (resin)
20 Kg of Part B (blowing Agent)
For a total of 40Kg of Material
Click Picture for more Info
These wedges are a must for removing parts from fibreglass composite moulds.
Click Picture for more Info
These wedges are a must for removing parts from fibreglass composite moulds.
Click Picture for more Info
These wedges are a must for removing parts from fibreglass composite molds.
